Description: Clever design allows precise bushing installation and depthing for clocks & watches using this new Sherline Mill accessory. Works with both a Sherline #5000 mill with a headstock spacer and a #5400...More Details »
Description: Radio Shack unit has variable volume control with a separate on/off switch. Can be married with #14905 sensor or other models. Runs on 9-volt battery, not included.
NOTE: Not Adams Brown manufactured.
Description: Economical way to obtain basic repair tools by buying them all in this kit. If purchased separately, retail would be $175. Great for students and beginners. Consists of 53 pieces (our Part numbers...More Details »
Description: 3-piece assortment. 3-3/4" brass body with nylon tips. Ideal for inserting watch hands without scratching dials. India. 2 different holes per color-coded tool:
-0.50mm & 1.00mm (White & Black)...More Details »
Description: Innovative tool that is used with the Webster mainspring winder. Place this arbor about 1" from end of arbor. Slide pin up to arbor and lock. Makes spring winding easier and safer. Update older Webster models with this support.
Description: Set of 10 arbors in a wood storage box. Double ended pins with a flat half-round end support pivots for polishing & are held in the lathe tailstock. Pins range in size from .024" to .116" (0.6-2.9mm). Note: Hold with a 5/16" or #80 Collet.
Description: Electronic Timer for clocks & watches. 2-3/4" x 7-1/2" x 8-3/4". Weighs 2 lbs. Optimized for regulating wrist & pocket watches. Direct reading of trains in beats per minute, balance, seconds per...More Details »
Description: Use on the bench or hang on the wall. 8-1/2” moveable arms can be used in the up or down position. Clearance for this is provided by the cutout section of the 10” wide base. 6-1/4” depth...More Details »
Description: Same as our #19550, but with a built-in beat amplifier. Micro Set is a new diagnostic tool for the clock repair shop and horological experimenter. This electronic timing device measures beat times...More Details »
Description: Align tool over a pivot hole and clamp it to your disassembled clock plate, insert the reamer holder and reamer and ream the bushing hole. Hex wrench and upright adapter are included. Reamers, bushings & clock plate are not included.
Description: Swiss made Presto #4 hand remover has a revolving turret with four plungers of different diameters to support the center post. Does not touch the dial. Removes hands from gauges, meters, clocks and watches. 3-3/4" long
Description: All the tools needed to work on Atmos clocks. Tube to insert suspension wire, hook to insert chain, hand puller, wrench (8mm) for balance nut, tool for slotted balance nut, movement holder, balance...More Details »